INGERSOLL RAND 231B-A626 1/2" DR. STANDARD ANVIL 2135TiMAX,232TGSL,231A,C,HP,XP

Description

Offered as shown is (1) brand new USA mined and made, specially heat treated and Rockwell Scale hardened steel anvil for any Ingersoll Rand tool requiring part #231B-A626
. This part may also match other similar: Blue Point, Matco, Mac, Cornwell and Harbor Freight tools. This is a new part. No fitment issues. No returns. No exchanges. No buyer remorse excuses that the parts are not as described or do not fit. It is on you to get right for your tool application before you buy. Ask for help before you buy and I will assist you to be sure. It is your job to verify the tool you have and either ask for my help or know the part number you are seeking.
This part is an exact fit and interchanges with any and all tools using Ingersoll Rand part #231B-A626 1/2" drive standard length anvils
. Do not overlook the thorough examination of the hammers on your existing tool while performing an anvil replacement.
My anvils are the NEW STYLE anvil. Early production IR 231 tools (typically older than 20 years) had an (OLD STYLE) anvil shaft that was a smaller diameter (measures 0.562" on the end) where the anvil fits into the hammer frame (bottom) for support and alignment. Looking at the NEW STYLE (anvil bottom end measures 0.825" wide) anvil I provide this is a replacement part for 100% of the IR family now. If your tool is over 20 years old it is important that you recognize this concern and compare your anvil shaft diameter to my anvil before you make this purchase. I do not sell the old style anvil. ebay tends to bring out the old and obsolete tools that buyers often fail to note may be an issue. If you are not sure what you have then shoot photos of your tool and the anvil you need to buy. I can look at your part and see that it should work with this anvil I offer.
If you have sharp edges or a wear pattern that can be felt with your finger nail on the inside of the hammer travel surface this will cause accelerated wear of a new anvil flanks and may be the reason why the old anvil wore out. Many ebay tool users in my experience do not want to spend the necessary money to correct the cause and effect problems with their air tools. Blaming a new anvil for the poor performance of a tool overlooks the possibility of worn out air motor vanes...which may have caused the destruction of the old anvil through longer-than-necessary and extended hammering time in both directions.
**This anvil will NOT fit any Ingersoll Rand 2235QTiMAX or 2235QiMAX tools.
For those IR focused tool users who demand only OEM Ingersoll Rand parts for their tools I recommend you consider saving money and buying USA made instead of the Chinese made parts that they, IR, offer for confiscatory prices.
Shipped as 8 ounces each first class mail. 2 or more anvils ship USPS Priority Air Mail. International shipping is done through the ebay Global Shipping Center in Erlanger, Kentucky. I ship this item to the USA and Puerto Rico directly.